P/90XXL

Molding machine for very large bra cups in fabric Single mold, for prototyping and small lots Mold diameter from 140 mm to 295 mm AMP PISANI innovative molding system in an heated upper bell and male mold rising from underneath the fabric support base. Significantly higher molding quality than conventional systems. The molding time is much shorter, and energy savings can be as high as 50% compared with conventional systems. The molding cycle consists of the descent from the top of a heated bell on the fabric then the mold underneath move upwards The normal molding cycle time is up to 20-25 sec depending of the type of material. Once the cycle is finished, the operator removes the molded cups and positions the new material. Very fast adjustment of the molding depth on a ruler. Time to change the molds is 2 min. No need to do any electrical connection. If the replaced molds have been preheated, the machine is ready to operate Each setting of temperature and times are adjustable with digital timers and thermoregulators. Machine equipped with PLC and operator terminal to set machine datas and display alarm messages